Crypto Ipsec Transform-Set Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
crypto ipsec transform-set <setname> <parameters>
Use the crypto ipsec transform-set command to define the transform configuration for securing data
(e.g., esp-3des, esp-sha-hmac, etc.). The transform set is then assigned to a crypto map using the map's
set transform-set command. Refer to set transform-set <setname1 - setname6>
For VPN configuration example scripts, refer to the technical support note VPN
Configuration Guide located on the ADTRAN OS Documentation CD provided with
your unit.
Syntax Description
<setname>
<parameters>
Default Values
There are no default settings for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, and 4000 and Total Access 900 Series
units.
Command History
Release 4.1
Functional Notes
Crypto map entries do not directly contain the transform configuration for securing data. Instead, the crypto
map is associated with transform sets which contain specific security algorithms.
If no transform set is configured for a crypto map, the entry is incomplete and will have no effect on the
system.
61200990L1-35E
Assigns a name to the transform set you are about to define.
Assigns a combination of up to three security algorithms. This field is a valid
combination of the following:
• ah-md5-hmac, ah-sha-hmac
• esp-des, esp-3des, esp-aes-128-cbc, esp-aes-192-cbc, esp-aes-256-cbc,
esp-null
• esp-md5-hmac, esp-sha-hmac
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
on page 1051.
329