Ip Ospf Network (Ppp Interface Configuration Command) - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ip ospf network [broadcast | point-to-point]
Use the ip ospf network command to specify the type of network on this interface.
Syntax Description
broadcast
point-to-point
Default Values
By default, Ethernet defaults to broadcast. PPP and Frame Relay default to point-to-point.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 3.1
Functional Notes
A point-to-point network will not elect designated routers.
Usage Examples
The following example designates a broadcast network type:
(config)#interface ppp 1
(config-ppp 1)#ip ospf network broadcast
61200990L1-35E
Sets the network type for broadcast.
Sets the network type for point-to-point.
Command was introduced.
Copyright © 2005 ADTRAN
PPP Interface Configuration Command Set
932