Spanning-Tree Pathcost Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
spanning-tree pathcost method [short | long]
Use the spanning-tree pathcost command to select a short or long pathcost method used by the
spanning-tree protocol.
Syntax Description
short
long
Default Values
By default, spanning-tree pathcost is set to short.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 5.1
Usage Examples
The following example specifies that the spanning-tree protocol use a long pathcost method:
(config)#spanning-tree pathcost method long
61200990L1-35E
Specifies a short pathcost method.
Specifies a long pathcost method.
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
464