Ip Pim-Sparse Propagation-Delay - To Use The Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ip pim-sparse propagation-delay <time>
Use the ip pim-sparse propagation-delay command to specify protocol-independent multicast (PIM)
sparse join/prune propagation delay. This is the expected propagation delay in milliseconds over the local
link. Use the no form of this command to return to the default value.
Syntax Description
<time>
Default Values
By default, the propagation-delay is set to 500 milliseconds.
Applicable Platforms
This command applies to the NetVanta 5000 and Total Access 900 Series units.
Command History
Release 11.1
Usage Examples
The following example sets the propagation-delay to 1000 milliseconds:
(config)#interface hdlc 1
(config-hdlc 1)#ip pim-sparse propagation-delay 1000
61200990L1-35E
Specifies the expected propagation delay in milliseconds. Valid range is 0 to
32,767 milliseconds.
Command was introduced.
Copyright © 2005 ADTRAN
HDLC Command Set
830