Dhcp Pool Command Set - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
DHCP P C
OOL
To activate the DHCP Pool mode, enter the ip dhcp-server pool command at the Global Configuration
mode prompt. For example:
>enable
#configure terminal
(config)#ip dhcp-server pool MyPool
(config-dhcp)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
client-identifier <identifier>
client-name <name>
default-router <address> <secondary>
dns-server <address> <secondary>
domain-name <domain>
hardware-address <hardware-address> <type>
host <address> [<subnet mask> or <prefix length>]
lease <days> <hours> <minutes>
netbios-name-server <address> <secondary>
netbios-node-type <type>
network <address> [<subnet mask> or <prefix length>]
ntp-server <ip address>
option <option value> [ascii | hex | ip] <value>
tftp-server <server>
timezone-offset <offset>
61200990L1-35E
S
OMMAND ET
on page 1146
on page 1148
on page 1149
on page 1150
on page 1151
on page 1155
on page 1157
on page 1159
on page 1161
on page 1162
Copyright © 2005 ADTRAN
on page 1152
on page 1154
on page 1156
on page 1158
on page 1160

DHCP Pool Command Set

1145