Show Ip Traffic Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
show ip traffic [realtime]
Use the show ip traffic command to display all IP traffic statistics.
Syntax Description
realtime
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 3.1
Release 10.1
Functional Notes
Use the realtime argument for this command to display full-screen output in real time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit
realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the
information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,
increase the terminal length (using the terminal length command; refer to
276
).
Usage Examples
>enable
#show ip traffic
61200990L1-35E
Displays full-screen output in real time. See the Functional Notes below for more
information.
Command was introduced.
The real time display option was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
terminal length <text> on page
230