Flowcontrol Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
flowcontrol [none | software in]
Use the flowcontrol command to set flow control for the line console.
Syntax Description
none
software in
Default Values
By default, flow control is set to none.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 3.1
Usage Examples
The following example configures no flow control for the line console:
(config)#line console 0
(config-con 0)#flowcontrol none
61200990L1-35E
Specifies no flow control.
Configures AOS to derive flow control from the attached device.
Command was introduced.
Copyright © 2005 ADTRAN
Line (Console) Interface Config Command Set
474