Snmp-Server Contact - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
snmp-server contact <"string">
Use the snmp-server contact command to specify the SNMP sysContact string. Use the no form of this
command to remove a configured contact.
Syntax Description
<"string">
Default Values
By default, the snmp-server contact is set to Customer Service.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1
Usage Examples
The following example specifies Network Administrator x4000 for the sysContact string:
(config)#snmp-server contact "Network Administrator x4000"
61200990L1-35E
Populates the sysContact string using an alphanumeric string enclosed in
quotation marks (up to 32 characters in length).
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
449