Crypto Ike Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
crypto ike
Use the crypto ike command to define the system-level local ID for IKE negotiations and to enter the IKE
Client or IKE Policy command sets.
Variations of this command include the following:
crypto ike client configuration pool <poolname>
crypto ike local-id address
crypto ike policy <policy priority>
Syntax Description
client configuration pool <poolname> Creates a local pool named the <poolname> of your choice and
local-id address
policy <policy priority>
Default Values
There are no default settings for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 4.1
Usage Examples
The following example creates an IKE policy with a policy priority setting of 1 and enters the IKE Policy for
that policy:
(config)#crypto ike policy 1
61200990L1-35E
enters the IKE Client. Clients that connect via an IKE policy that
specifies this pool-name will be assigned values from this pool.
Refer to the section
more information.
Sets the local ID during IKE negotiation to be the IP address of
the interface from which the traffic exits. This setting can be
overridden on a per-policy basis using the local-id command in
the IKE Policy (refer to
user-fqdn] <ipaddress or name>
information).
Creates an IKE policy with the <policy priority> of your choice and
enters the IKE Policy. Refer to
1073
for more information.
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
IKE Client Command Set
local-id [address | asn1-dn | fqdn |
on page 1080
IKE Policy Command Set
on page 1063
for
for more
on page
322