Set Interface Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
set interface <interface type> <interface id>
Use the set interface command to specify an output interface for the packet. Multiple interfaces can be
specified. The router forwards the packet along the first usable interface. Use the no form of this command
to cancel output from the specified interface.
Syntax Description
<interface>
<interface id>
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 2000 and 5000 Series, and Total Access 900 Series units.
Command History
Release 11.1
Usage Examples
The following example sets the output interface as PPP 1:
(config)#route-map MyMap permit 100
(config-route-map)#set interface ppp 1
61200990L1-35E
Sets output interface type for the packet. Type set interface ? for
a list of valid interfaces.
Specifies the ID of the specified interface type.
Command was introduced.
Copyright © 2005 ADTRAN
Route Map Command Set
1185