Encapsulation 802.1Q Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide Ethernet Interface Configuration Command Set
encapsulation 802.1q
Use the encapsulation 802.1q command to put the interface into 802.1q (VLAN) mode.
Syntax Description
No subcommands.
Default Values
No default value is necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 6.1 Command was introduced.
Usage Examples
The following example puts interface eth 0/1 in 802.1q mode and configures a sub-interface for VLAN
usage:
(config)#interface ethernet 0/1
(config-eth 0/1)#encapsulation 802.1q
(config-eth 0/1)#interface ethernet 0/1.1
(config-eth 0/1.1)vlan-id 3
61200990L1-35E Copyright © 2005 ADTRAN 540