Set Ip Precedence Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
set ip precedence [<value> | critical | flash | flash-override | immediate |
internet | network | priority | routine]
Use the set ip precedence command to set the precedence value in the IP header of the packet. Use the no
form of this command to remove the precedence value.
Syntax Description
<value>
routine
priority
immediate
flash
flash-override
critical
internet
network
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 2000 and 5000 Series, and Total Access 900 Series units.
Command History
Release 11.1
Usage Examples
The following example sets an IP precedence value of critical in the IP header of the route map named
MyMap:
(config)#route-map MyMap permit 100
(config-route-map)#set ip precedence critical
61200990L1-35E
Sets the IP precedence (in numeric value). (Valid range: 0 to 7 in
ascending order of importance.)
Sets the IP precedence as routine. (Numeric value of 0.)
Sets the IP precedence as priority. (Numeric value of 1.)
Sets the IP precedence as immediate. (Numeric value of 2.)
Sets the IP precedence as flash. (Numeric value of 3.)
Sets the IP precedence as flash-override. (Numeric value of 4.)
Sets the IP precedence as critical. (Numeric value of 5.)
Sets the IP precedence as internet. (Numeric value of 6.) This level is
reserved for internal network use.
Sets the IP precedence as network. (Numeric value of 7.) This level is
reserved for internal network use.
Command was introduced.
Copyright © 2005 ADTRAN
Route Map Command Set
1190