Spanning-Tree Edgeport Bpdufilter Default Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide Global Configuration Mode Command Set
spanning-tree edgeport bpdufilter default
Use the spanning-tree edgeport bpdufilter default command to enable the BPDU filter on all ports by
default. Use the no form of this command to disable the setting.
Syntax Description
No subcommands.
Default Values
Disabled by default.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 5.1 Command was introduced.
Functional Notes
The BPDU filter blocks any BPDUs from being transmitted and received on an interface. This can be
overridden on an individual port.
Usage Examples
The following example enables the bpdufilter on all ports by default:
(config)#spanning-tree edgeport bpdufilter default
To disable the BPDU filter on a specific interface, issue the appropriate commands for the given interface
using the following commands as an example:
(config)#interface ethernet 0/1
(config-eth 0/1)#spanning-tree bpdufilter disable
61200990L1-35E Copyright © 2005 ADTRAN 457