Spanning-Tree Edgeport - Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide Frame Relay Sub-Interface Config Command Set
spanning-tree edgeport
Use the spanning-tree edgeport command to set this interface to be an edgeport. This command overrides
the Global setting (refer to spanning-tree edgeport default on page 459). Use the no form of this command
to return to the default value.
Syntax Description
No subcommands.
Default Values
By default, this command is set to disable.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 5.1 Command was introduced.
Usage Examples
The following example configures the interface to be an edgeport:
(config)#interface frame-relay 1.16
(config-fr 1.16)#spanning-tree edgeport
An individual interface can be configured to not be considered an edgeport. For example:
(config)#interface frame-relay 1.16
(config-fr 1.16)#spanning-tree edgeport disable
or
(config)#interface frame-relay 1.16
(config-fr 1.16)#no spanning-tree edgeport
61200990L1-35E Copyright © 2005 ADTRAN 778