Show Ip Route Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
show ip route [connected | ospf | rip | static | table | bgp | summary |
summary realtime | <ip address> <subnet>]
Use the show ip route command to display the contents of the IP route table.
Syntax Description
connected
ospf
rip
static
table
bgp
summary
summary realtime
<ip address><subnet> Displays only the IP routes to destinations within the given address and subnet.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1
Release 10.1
Functional Notes
Use the realtime argument for this command to display full-screen output in real time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit
realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the
information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,
increase the terminal length (using the terminal length command; refer to
276
).
61200990L1-35E
Optional. Displays only the IP routes for directly connected networks.
Optional. Displays only the IP routes associated with OSPF.
Optional. Displays only the IP routes that were dynamically learned through RIP.
Optional. Displays only the IP routes that were statically entered.
Optional. Displays a condensed version of the IP route table.
Displays only the IP routes associated with BGP.
Optional. Displays a summary of all IP route information.
Optional. Displays full-screen output in realtime. See the Functional Notes below
for more information.
Command was introduced.
The real time display option was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
terminal length <text> on page
228