Show Ip Bgp Neighbors Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
show ip bgp neighbors <ip address>
Use the show ip bgp neighbors command to display information for the specified Border Gateway
Protocol (BGP) neighbor. Variations of this command include the following:
show ip bgp neighbors
show ip bgp neighbors <ip address>
show ip bgp neighbors <ip address> [advertised-routes | received-routes | routes]
Syntax Description
<ip address>
advertised-routes
received-routes
routes
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 8.1
Functional Notes
Entries that are not filtered by prefix lists are marked with an asterisk (*) to show they are valid. Entries that
are deemed the best path to advertised route are marked with a caret (>).
61200990L1-35E
Displays information for the specified neighbor. If no IP address is entered,
information for all neighbors is displayed.
Displays all routes being advertised to the specified neighbor. Command output is
the same as for show ip bgp except filtered to only the BGP routes being
advertised to the specified neighbor.
Displays all routes (accepted and rejected) advertised by the specified neighbor.
Routes may be rejected by inbound filters such as prefix list filters.
Displays all accepted received routes advertised by the specified neighbor.
Routes displayed have passed inbound filtering. This command output is the
same as show ip bgp except the output is filtered to those learned from the
specified neighbor.
Command was introduced.
Copyright © 2005 ADTRAN
Enable Mode Command Set
199