Client Authentication Host Xauth-Type Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
client authentication host xauth-type [generic | otp | radius]
Use the client authentication host xauth-type command to allow the user to specify the Xauth
authentication type if a type other than generic is desired.
Syntax Description
generic
otp
radius
Default Values
By default, this is set to generic.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 5.1
Functional Notes
This command is used along with the client authentication host username. Refer to
pool <poolname> on page 1078
the user to specify the Xauth authentication type if a type other than generic is desired.
Usage Examples
The following example sets the Xauth type to radius:
(config-ike)#client authentication host xauth-type radius
61200990L1-35E
Specifies generic authentication type.
Specifies OTP authentication type.
Specifies RADIUS authentication type.
Command was introduced.
for more information. When acting as an Xauth host, this command allows
Copyright © 2005 ADTRAN
IKE Policy Command Set
client configuration
1076