Bandwidth - To Use The Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
bandwidth <value>
Use the bandwidth command to provide the bandwidth value of an interface to the higher-level protocols.
This value is used in cost calculations. Use the no form of this command to restore the default values.
Syntax Description
<value>
Default Values
No default value is necessary for this command.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 3.1
Functional Notes
The bandwidth command is an informational value that is communicated to the higher-level protocols to
be used in cost calculations. This is a routing parameter only and does not affect the physical interface.
Usage Examples
The following example sets bandwidth of the Frame Relay interface to 10 Mbps:
(config)#interface frame-relay 1
(config-fr 1)#bandwidth 10000
61200990L1-35E
Specifies bandwidth in kbps.
Command was introduced.
Copyright © 2005 ADTRAN
Frame Relay Interface Config Command Set
693