Snmp-Server Contact Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
snmp-server contact [email | pager | phone] <number>
Use the snmp-server contact command to specify the email address, pager number, or phone number. Use
the no form of this command to remove a configured contact.
Syntax Description
email
pager
phone
<number>
Default Values
No default values necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 10.1
Usage Examples
The following example specifies 6536999 for the pager number:
(config)#snmp-server contact pager 6536999
61200990L1-35E
Specifies email address for the SNMP server contact.
Specifies pager number for the SNMP server contact.
Specifies phone number for the SNMP server contact.
Identifies the contact (up to 32 characters in length).
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
448