Ppp Pap Sent-Username/Password Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ppp pap sent-username <username> password <password>
Use the ppp pap sent-username/password command to configure a username and password when the
peer requires PAP PPP authentication. Use the no form of this command to remove a configured password.
For more information on PAP and CHAP functionality, refer to the Technology Review section for the
command ppp authentication [chap | eap | pap]
Syntax Description
<username>
<password>
Default Values
By default, there is no defined ppp pap sent-username and password.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 1.1
Release 11.1
Usage Examples
The following example specifies a PPP PAP sent-username of local and a password of my_password:
(config)#interface demand 1
(config-demand 1)#ppp pap sent-username local password my_password
61200990L1-35E
Specifies a username by alphanumeric string up to 80 characters in length (the
username is case-sensitive).
Specifies a password by alphanumeric string up to 80 characters in length (the
password is case-sensitive).
Command was introduced.
Command expanded to include the demand interface.
Copyright © 2005 ADTRAN
Demand Interface Configuration Command Set
on page 680.
687