Hardware-Address Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
hardware-address <hardware-address> <type>
Use the hardware-address command to specify the name of a Dynamic Host Configuration Protocol
(DHCP) client. Use the no form of this command to remove the configured client name.
Syntax Description
<hardware-address>
<type>
61200990L1-35E
Specifies the hardware address (in hexadecimal notation with colon delimiters) of
the preferred router on the client's subnet (example d2:17:04:91:11:50).
Optional. Specifies the hardware protocol of the DHCP client.
The hardware type field can be entered as follows:
ethernet Specifies standard Ethernet networks.
ieee802 Specifies IEEE 802 standard networks.
<1-21> Enter one of the hardware types listed in RFC1700.
The valid hardware types are as follows:
1 10 Mb Ethernet
2 Experimental 3 Mb Ethernet
3 Amateur Radio AX.25
4 Proteon ProNET Token Ring
5 Chaos
6 IEEE 802 Networks
7 ARCNET
8 Hyperchannel
9 Lanstar
10 Autonet Short Address
11 LocalTalk
12 LocalNet (IBM PCNet or SYTEK LocalNet)
13 Ultra link
14 SMDS
15 Frame Relay
16 Asynchronous Transmission Mode (ATM)
17 HDLC
18 Fibre Channel
19 Asynchronous Transmission Mode (ATM)
20 Serial Line
21 Asynchronous Transmission Mode (ATM)
Copyright © 2005 ADTRAN
DHCP Pool Command Set
1152