Show Lldp Device Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
show lldp device <system name>
Use the show lldp device command to display specific neighbor information about a given neighbor.
Syntax Description
<system name>
Default Values
No default values are necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 8.1
Functional Notes
If there is more than one neighbor with the same system name, all neighbors with that system name will be
displayed.
Usage Examples
The following example shows specific information about a neighbor for the system name Router:
>enable
#show lldp device Router
Chassis ID: 00:A0:C8:02:DD:2A (MAC Address)
61200990L1-35E
Specifies the system name of the neighbor to display.
Command was introduced.
System Name: Router
Device Port: eth 0/1 (Locally Assigned)
Holdtime: 30
Platform: NetVanta 3305
Software: Version: 08.00.22.sw1.D, Date: Mon Nov 01 10:28:55 2004
Capabilities: Bridge, Router
Enabled Capabilities: Router
Local Port: eth 0/3
Management Addresses:
Address Type: IP version 4, Address: 10.23.10.10
Interface Type: Interface Index, Interface Id: 2
Copyright © 2005 ADTRAN
Enable Mode Command Set
232