Line (Ssh) Interface Config Command Set - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
L (SSH) I
INE NTERFACE
To activate the Line Secure Shell (SSH) Interface Configuration mode, enter the line ssh command
specifying a SSH session(s) at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#line ssh 0 4
(config-ssh0-4)#
You can select a single line by entering the line ssh command followed by the line number (0-4). For
example:
>enable
#configure terminal
(config)#line ssh 2
(config-ssh2)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-class <listname> in
accounting commands [<level> l <name> l default]
authorization commands [<level> l <name> l default]
line-timeout <minutes>
login on page 488
login authentication <aaa login list>
login local-userlist
61200990L1-35E
C
ONFIG
on page 484
on page 487
on page 489
on page 490
Copyright © 2005 ADTRAN

Line (SSH) Interface Config Command Set

C S
OMMAND ET
on page 485
on page 486
483