Snmp Trap - Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
snmp trap
Use the snmp trap command to enable all supported Simple Network Management Protocol (SNMP)
traps on the interface.
Syntax Description
No subcommands.
Default Values
By default, all interfaces (except virtual Frame Relay interfaces and sub-interfaces) have SNMP traps
enabled.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 1.1
Release 3.1
Release 5.1
Usage Examples
The following example enables SNMP on the virtual Frame Relay interface:
(config)#interface frame-relay 1
(config-fr 1)#snmp trap
61200990L1-35E
Command was introduced.
Command was extended to the SHDSL interface.
Command was expanded to include Ethernet sub-interfaces and Gigabit Ethernet
interfaces.
Copyright © 2005 ADTRAN
Frame Relay Interface Config Command Set
712