Line (Console) Interface Config Command Set - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
L (C
INE ONSOLE
To activate the Line (Console) Interface Configuration mode, enter the line console 0 command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#line console 0
(config-con 0)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do on page 32
end on page 33
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
accounting commands [<level> l <name> l default]
authorization commands [<level> l <name> l default]
databits [7 | 8] on page 473
flowcontrol [none | software in]
line-timeout <minutes>
login on page 476
login authentication <aaa login list>
login local-userlist
parity [even | mark | none | odd | space]
password [md5] <password>
speed <rate> on page 481
stopbits [1 | 2] on page 482
61200990L1-35E
) I
NTERFACE
on page 474
on page 475
on page 477
on page 478
on page 479
on page 480
Copyright © 2005 ADTRAN

Line (Console) Interface Config Command Set

C C
ONFIG OMMAND
on page 471
on page 472
S
ET
470