Prefix-List Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
prefix-list <listname> [in | out]
Use the prefix-list command to assign a predefined prefix list to a BGP neighbor. The list is then used to
filter BGP route updates received and/or sent from/by the specified peer. Use the no form of this command
to discontinue use of the prefix list.
Syntax Description
<listname>
in
out
Default Values
By default, no prefix lists are specified for filtering.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 9.3
Functional Notes
Before they can be assigned to a BGP neighbor, prefix lists must first be defined using the ip prefix-list
ip prefix-list <listname> description <"text">
command. See
Usage Examples
The following example uses the MyList prefix list to filter all BGP updates received from the specified peer:
(config)#router bgp-neighbor 192.22.73.101
(config-bgp-neighbor)#prefix-list MyList in
61200990L1-35E
Assigns a prefix list to this BGP neighbor.
Specifies the filtering of all inbound BGP route updates received from the
specified peer.
Specifies the filtering of all outbound BGP route updates being sent to the
specified peer.
Command was introduced.
Copyright © 2005 ADTRAN
BGP Neighbor Configuration Command Set
on page 397
for more information.
1105