Bgp Neighbor Configuration Command Set - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
BGP N
EIGHBOR
To activate the BGP Neighbor Configuration mode, enter the router bgp-neighbor command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#router bgp-neighbor 192.22.73.101
(config-bgp-neighbor)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-list <listname> [in | out]
advertisement-interval <seconds>
as-path-list <listname> [in | out]
ebgp-multihop <hop count>
hold-timer <hold time>
local-as <as-number>
next-hop-self on page 1103
password <password>
prefix-list <listname> [in | out]
remote-as <as-number>
route-map <map-name> [in | out]
send-community standard
soft-reconfiguration inbound
update-source <interface>
61200990L1-35E
C
ONFIGURATION
on page 31
on page 1096
on page 1097
on page 1098
on page 1099
on page 1100
on page 1101
on page 1104
on page 1105
on page 1106
on page 1107
on page 1108
on page 1109
on page 1110
Copyright © 2005 ADTRAN

BGP Neighbor Configuration Command Set

C S
OMMAND ET
1095