Ip Radius Source-Interface Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ip radius source-interface <interface>
Use the ip radius source-interface command to specify the network-attached storage (NAS) IP address
attribute passed with the RADIUS authentication request packet.
Syntax Description
<interface>
Default Values
By default, no source interface is defined.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 5.1
Functional Notes
If this value is not defined, the address of the source network interface is used.
Usage Examples
The following example configures the Ethernet 0/1 port to be the source interface:
(config)#ip radius source-interface ethernet 0/1
61200990L1-35E
Specifies the source interface (in the format type slot/port). Type ip radius
source-interface ? for a complete list of interfaces.
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
400