Snmp Trap Link-Status - Using The Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
snmp trap link-status
Use the snmp trap link-status command to control the Simple Network Management Protocol (SNMP)
variable ifLinkUpDownTrapEnable (RFC2863) to enable (or disable) the interface to send SNMP traps
when there is an interface status change. Use the no form of this command to disable this trap.
Syntax Description
No subcommands.
Default Values
By default, the ifLinkUpDownTrapEnable OID is enabled for all interfaces except virtual Frame Relay
interfaces.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 1.1
Release 11.1
Functional Notes
The snmp trap link-status command is used to control the RFC2863 ifLinkUpDownTrapEnable OID (OID
number 1.3.6.1.2.1.31.1.1.1.14.0).
Usage Examples
The following example disables the link-status trap on the virtual demand interface:
(config)#interface demand 1
(config-demand 1)#no snmp trap link-status
61200990L1-35E
Command was introduced.
Command expanded to include the demand interface.
Copyright © 2005 ADTRAN
Demand Interface Configuration Command Set
690