Spt-Threshold Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
spt-threshold <packets> infinity
Use the spt-threshold command to change the PIM Sparse Shortest Path Tree (SPT) threshold, which
specifies the number of packets the router sends using the rendezvous point (RP) before switching to the
SPT.
Syntax Description
<packets>
infinity
Default Values
By default, the SPT threshold is set to 1 packet.
Applicable Platforms
This command applies to the NetVanta 2000 and 5000 and the Total Access 900 Series units.
Command History
Release 11.1
Usage Examples
The following example sets the SPT threshold at five packets:
(config)#router pim-sparse
(config-pim-sparse)#spt-threshold 5
61200990L1-35E
Specifies the number of packets the routing switch sends using the RP
before switching to the SPT. Valid range: 1 to 4294967295.
Causes all sources to use the shared RP tree.
Command was introduced.
Copyright © 2005 ADTRAN
Router (PIM Sparse) Configuration Command Set
1133