Snmp Trap Line-Status - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide T1 Interface Configuration Command Set

snmp trap line-status

Use the snmp trap line-status command to control the Simple Network Management Protocol (SNMP)
variable dsx1LineStatusChangeTrapEnable (RFC2495) to enable (or disable) the interface to send SNMP
traps when there is an interface status change. Use the no form of this command to disable this trap.
Syntax Description
No subcommands.
Default Values
By default, the dsx1LineStatusChangeTrapEnable OID is set to enabled for all interfaces except virtual
Frame Relay Interfaces.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 11.1 Command was introduced.
Functional Notes
The snmp trap line-status command is used to control the RFC2495 dsx1LineStatusChangeTrapEnable
OID (OID number 1.3.6.1.2.1.10.18.6.1.17.0).
Usage Examples
The following example disables the line-status trap on the T1 interface:
(config)#interface t1 1/1
(config-t1 1/1)#no snmp trap line-status
61200990L1-35E Copyright © 2005 ADTRAN 615