Bandwidth - Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
bandwidth <value>
Use the bandwidth command to provide the bandwidth value of an interface to the higher-level protocols.
This value is used in cost calculations. Use the no form of this command to restore the default values.
Syntax Description
<value>
Default Values
To view default values, use the show interfaces command.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 3.1
Release 11.1
Functional Notes
The bandwidth command is an informational value that is communicated to the higher-level protocols to
be used in cost calculations. This is a routing parameter only and does not affect the physical interface.
Usage Examples
The following example sets the bandwidth of the demand interface to 10 Mbps:
(config)#interface demand 1
(config-demand 1)#bandwidth 10000
61200990L1-35E
Specifies the bandwidth value in kbps.
Command was introduced.
Command expanded to include the demand interface.
Copyright © 2005 ADTRAN
Demand Interface Configuration Command Set
636