Ip Firewall Alg Sip Udp Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ip firewall alg sip udp <port#>
Use the ip firewall alg sip udp command to configure the user datagram protocol (UDP) port for Session
Initiation Protocol (SIP) application-level gateways (ALG). Use the no form of this command to return to
the default settings.
Syntax Description
udp <port#>
Default Values
By default, the ALG for SIP is enabled and the UDP port is set to 5060.
Applicable Platforms
This command applies to the NetVanta 2000 and 5000 and Total Access 900 Series units.
Command History
Release 11.1
Usage Examples
The following example enables port 1020 for UDP:
(config)#ip firewall alg sip udp 1020
61200990L1-35E
Sets the UDP port. Valid range: 1 to 65,535.
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
372