Connect-Mode Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
connect-mode [answer | originate | either]
Use the connect-mode command to configure the interface to only answer calls, only originate calls, or to
both answer and originate calls. Use the no form of this command to restore the default values.
Syntax Description
answer
originate
either
Default Values
By default the connect mode is set to both answer and originate calls.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 11.1
Usage Examples
The following example configures demand interface 1 to only answer calls:
(config)#interface demand 1
(config-demand 1)#connect-mode answer
61200990L1-35E
Specifies the interface may be used to answer calls but not originate calls.
Specifies the interface may be used to originate calls but not answer calls.
Specifies the interface may be used to answer and originate calls.
Command was introduced.
Copyright © 2005 ADTRAN
Demand Interface Configuration Command Set
639