Ip Rip Receive Version - To Use The Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ip rip receive version [1 | 2]
Use the ip rip receive version command to configure the RIP version the unit accepts in all RIP packets
received on the interface. Use the no form of this command to restore the default value.
Syntax Description
1
2
Default Values
By default, all interfaces implement RIP version 1 (the default value for the version command).
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 3000, 4000, and 5000 and Total Access 900 Series
units.
Command History
Release 9.1
Functional Notes
Use the ip rip receive version command to specify a RIP version that overrides the version (in the
Router RIP) configuration. See
The AOS only accepts one version (either 1 or 2) on a given interface.
Usage Examples
The following example configures the HDLC interface to accept only RIP version 2 packets:
(config)#interface hdlc 1
(config-hdlc 1)#ip rip receive version 2
61200990L1-35E
Only accept received RIP version 1 packets on the interface.
Only accept received RIP version 2 packets on the interface.
Command was introduced.
version [1 | 2] on page 1144
Copyright © 2005 ADTRAN
for more information.
HDLC Command Set
833