Ethernet Interface Configuration Command Set; To Activate The Basic Ethernet Interface Configuration Mode; To Activate The Gigabit Ethernet Interface Configuration Mode; To Activate The Ethernet Sub-Interface Configuration Mode - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
E I
THERNET NTERFACE
There are four types of Ethernet interfaces associated with the AOS:
• Basic Ethernet interfaces (e.g., eth 0/1)
• Gigabit Ethernet interfaces (e.g., giga-eth 0/3)
• Ethernet sub-interfaces associated with a VLAN (e.g., eth 0/1.1)
• Ethernet interface range (e.g., eth 0/1, 0/8)
To activate the basic Ethernet Interface Configuration mode, enter the interface ethernet command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface ethernet 0/1
(config-eth 0/1)#
To activate the Gigabit Ethernet Interface Configuration mode, enter the interface gigabit-ethernet
command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface gigabit-ethernet 0/3
(config-giga-eth 0/3)#
To activate the Ethernet Sub-Interface Configuration mode, enter the interface ethernet command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface ethernet 0/1.1
(config-eth 0/1.1)#
To activate the Ethernet Configuration mode for a range of Ethernet interfaces, enter the interface range
command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#interface range ethernet 0/1, 0/8
(config-eth 0/1, 0/8)#
61200990L1-35E

Ethernet Interface Configuration Command Set

C
ONFIGURATION
Copyright © 2005 ADTRAN
C S
OMMAND ET
527