Table of Contents
Advertisement
Command Reference Guide
HDLC C
OMMAND
To activate the HDLC mode, enter the interface hdcl command at the Global Configuration mode prompt.
For example:
>enable
#configure terminal
(config)#interface hdlc 1
(config-hdlc 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <"text">
on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text>
do
on page 32
end
on page 33
exit
on page 34
shutdown
on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname>
alias link<"text">
bandwidth <value>
bridge-group <group#>
crypto map <mapname>
dial-backup commands
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username>
<password>
on page 808
fair-queue <threshold>
hold-queue <queue size> out
ip commands begin on
keepalive <seconds>
lldp receive
on page 838
lldp send [management-address l port-description l system-capabilities l system-description l
system-name l and-receive]
61200990L1-35E
S
ET
on page 31
on page 784
on page 787
on page 788
on page 789
on page 790
on page 792
on page 810
on page 811
page 812
on page 837
on page 839
Copyright © 2005 ADTRAN
HDLC Command Set
782
- Quick Links:
- Basic Mode Command Set
- Common Commands
Hide quick links:
Advertisement
Table of Contents
