Ip Ospf Command To Customize Ospf Settings - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ip ospf
Use the ip ospf command to customize OSPF settings (if needed).
Syntax Description
authentication-key
<password>
cost <value>
dead-interval <seconds>
hello-interval <seconds>
message-digest-key
<keyid> md5 <key>
priority <value>
retransmit-interval
<seconds>
transmit-delay <seconds>
Default Values
retransmit-interval <seconds>
transmit-delay <seconds>
hello-interval <seconds>
dead-interval <seconds>
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 3.1
61200990L1-35E
Assigns a simple-text authentication password to be used by other routers
using the OSPF simple password authentication.
Specifies he OSPF cost of sending a packet on the interface. This value
overrides any computed cost value. Range: 165,535.
Sets the maximum interval allowed between hello packets. If the maximum
is exceeded, neighboring devices will determine that the device is down.
Range: 0 to 32,767.
Specifies the interval between hello packets sent on the interface. Range: 0
to 32,767.
Configures OSPF Message Digest 5 (MD5) authentication (16-byte
maximum) keys.
Sets the OSPF priority. The value set in this field helps determine the
designated router for this network. Range: 0-255.
Specifies the time between link-state advertisements (LSAs). Range: 0 to
32,767.
Sets the estimated time required to send an LSA on the interface. Range: 0
to 32,767.
5 seconds
1 second
10 seconds: Ethernet, point-to-point, Frame Relay, and PPP
40 seconds
Command was introduced.
Copyright © 2005 ADTRAN
Frame Relay Sub-Interface Config Command Set
757