Snmp-Server Source-Interface Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
snmp-server source-interface <interface>
Use the snmp-server source-interface command to tell the AOS the interface type from which to expect
the SNMP traps to originate. All SNMP originated packets (including traps and get/set requests) will use
the designated interface's IP address. Use the no form of this command to remove specified interfaces.
Syntax Description
<interface>
Default Values
By default, there are no trap-source interfaces defined.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 7.1
Usage Examples
The following example specifies that the Ethernet interface (ethernet 0/1) should be the source for all
SNMP traps and get/set requests:
(config)#snmp-server source-interface ethernet 0/1
61200990L1-35E
Specifies the physical interface that should originate SNMP traps. Enter
snmp-server trap-source ? for a complete list of valid interfaces.
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
454