Spanning-Tree Priority Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
spanning-tree priority <value>
Use the spanning-tree priority command to set the priority for spanning-tree interfaces. The lower the
priority value, the higher the likelihood the configured spanning-tree interface will be the root for the
bridge group. To return to the default bridge priority value, use the no version of this command.
Syntax Description
<value>
Default Values
By default, the priority level is set to 32768.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 5.1
Usage Examples
The following example sets spanning-tree priority to the maximum level:
(config)#spanning-tree priority 0
61200990L1-35E
Sets a priority value for the bridge interface. Configuring this value to a low
number increases the interface's chance of being the root. Therefore, the
maximum priority level would be 0. Range: 0 to 65,535.
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
465