Logging Email Priority-Level Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
logging email priority-level [error | fatal | info | notice | warning]
Use the logging email priority-level command to set the threshold for events sent to the addresses
specified using the logging email address-list command. All events with the specified priority or higher
will be sent to all addresses in the list. The logging email on command must be enabled. Refer to logging
email address-list <email address> ; <email address>
related information. Use the no form of this command to return to the default priority.
Syntax Description
Sets the minimum priority threshold for sending messages to email addresses specified using the logging
email address-list command.
The following priorities are available (ranking from lowest to highest):
error
fatal
info
notice
warning
Default Values
By default, the logging email priority-level is set to warning.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 2000, 3000, 4000, and 5000 and
Total Access 900 Series units.
Command History
Release 1.1
Usage Examples
The following example sends all messages with warning level or greater to the email addresses listed
using the logging email address-list command:
(config)#logging email priority-level warning
61200990L1-35E
Logs events with error and fatal priorities.
Logs only events with a fatal priority.
Logs all events.
Logs events with notice, warning, error, and fatal priorities.
Logs events with warning, error, and fatal priorities.
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
on page 418 and logging email on on page 420 for
421