Route Map Command Set - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
R M C
OUTE AP
To activate the Route Map Interface Configuration mode, enter the route-map command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#route-map MyMap permit 100
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
do on page 32
exit on page 34
All other commands for this command set are described in this section in alphabetical order.
match as-path <name>
match community <name> [exact-match]
match ip address <access list name>
match ip address prefix-list <prefix-list name>
match ip dscp [<value> | afxx | csxx | default | ef]
match ip precedence [<value> | critical | flash | flash-override | immediate | internet | network |
priority | routine]
match metric <value>
match length <minimum> <maximum>
set as-path prepend [<number> | last-as <number>]
set comm-list <name> delete
set local-preference <value>
set metric <value>
set default interface <interface type> <interface id>
set interface <interface type> <interface id>
set ip default next-hop <ip address>
set ip df on page 1187
set ip dscp [<value> | afxx | csxx | default | ef]
set ip next-hop <ip address>
set ip precedence [<value> | critical | flash | flash-override | immediate | internet | network | priority |
routine] on page 1190
61200990L1-35E
S
OMMAND ET
on page 1172
on page 1173
on page 1174
on page 1177
on page 1178
on page 1179
on page 1181
on page 1182
on page 1183
on page 1186
on page 1189
Copyright © 2005 ADTRAN
on page 1175
on page 1176
on page 1180
on page 1184
on page 1185
on page 1188

Route Map Command Set

1171