Match As-Path Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide Route Map Command Set
match as-path <name>
Use the match as-path command to configure the route map to route traffic based on the AS path list
name. Use the no form of this command to discontinue matching.
Syntax Description
<name> Specifies the name of the AS path list you want to match.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 Series and
Total Access 900 Series units.
Command History
Release 10.1 Command was introduced.
Usage Examples
The following example instructs the route map named MyMap to match the AS path list named TestPath:
(config)#route-map MyMap permit 100
(config-route-map)#match as-path TestPath
61200990L1-35E Copyright © 2005 ADTRAN 1172