Ip Rip Receive Version [1/2] Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ip rip receive version [1 | 2]
Use the ip rip receive version command to configure the RIP version the unit accepts in all RIP packets
received on the interface. Use the no form of this command to restore the default value.
Syntax Description
1
2
Default Values
By default, all interfaces implement RIP version 1 (the default value for the version command).
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 Series units.
Command History
Release 1.1
Release 11.1
Functional Notes
Use the ip rip receive version to specify a RIP version that overrides the version (in the Router RIP)
configuration.
The AOS only accepts one version (either 1 or 2) on a given interface.
Usage Examples
The following example configures the virtual demand interface to accept only RIP version 2 packets:
(config)#interface demand 1
(config-demand 1)#ip rip receive version 2
61200990L1-35E
Accepts only received RIP version 1 packets on the interface.
Accepts only received RIP version 2 packets on the interface.
Command was introduced.
Command expanded to include the demand interface.
Copyright © 2005 ADTRAN
Demand Interface Configuration Command Set
669