Ip Rip Send Version Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ip rip send version [1 | 2]
Use the ip rip send version command to configure the RIP version the unit sends in all RIP packets
transmitted on the interface.
Syntax Description
1
2
Default Values
By default, all interfaces transmit RIP version 1 (the default value for the version command).
Applicable Platforms
This command applies to the NetVanta 2000, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 1.1
Release 5.1
Functional Notes
Use the ip rip send version command to specify a RIP version that overrides the version (in the Router
RIP) configuration. Refer to
The AOS only transmits one version (either 1 or 2) on a given interface.
Usage Examples
The following example configures the Ethernet interface to transmit only RIP version 2 packets:
(config)#interface eth 0/1
(config-eth 0/1)#ip rip send version 2
61200990L1-35E
Transmits only RIP version 1 packets on the interface.
Transmits only RIP version 2 packets on the interface.
Command was introduced.
Command was expanded to include Ethernet sub-interfaces.
version [1 | 2] on page 1144
Copyright © 2005 ADTRAN
Ethernet Interface Configuration Command Set
for more information.
570