Ip Pim-Sparse Nbr-Timeout - To Use The Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
ip pim-sparse nbr-timeout <time>
Use the ip pim-sparse nbr-timeout command to specify protocol-independent multicast (PIM) sparse
neighbor timeout. This is the time interval after which a PIM-capable router will consider a neighbor not
present. Use the no form of this command to return to the default value.
Syntax Description
<time>
Default Values
By default, the nbr-timeout is set to 105 seconds.
Applicable Platforms
This command applies to the NetVanta 5000 and Total Access 900 Series units.
Command History
Release 11.1
Usage Examples
The following example sets the nbr-timeout to 300 seconds:
(config)#interface hdlc 1
(config-hdlc 1)#ip pim-sparse nbr-timeout 300
61200990L1-35E
Specifies the time interval in seconds after which a neighbor is considered not
present. Valid range is 30 to 10,800 seconds.
Command was introduced.
Copyright © 2005 ADTRAN
HDLC Command Set
828