Default-Metric Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
default-metric <value>
Use the default-metric command to set a metric value for redistributed routes.
Syntax Description
<value>
Default Values
By default, default-metric value is set at 20.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 3.1
Functional Notes
The metric value defined using the redistribute command overrides the default-metric command's metric
redistribute ospf [metric <value>]
setting. Refer to
Usage Examples
The following example shows a router using both RIP and OSPF routing protocols. The example
advertises RIP-derived routes using the OSPF protocol and assigns the RIP-derived routes an OSPF
metric of 10.
(config)#router ospf
(config-ospf)#default-metric 10
(config-ospf)#redistribute rip
61200990L1-35E
Sets the default metric value (range: 0 to 4,294,967,295).
Command was introduced.
Copyright © 2005 ADTRAN
Router (OSPF) Configuration Command Set
on page 1140
for related information.
1120