Ip Load-Sharing Command; Ip Load-Sharing [Per-Destination | Per-Packet - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide

ip load-sharing [per-destination | per-packet]

Use the ip load-sharing command to configure whether parallel routes in the route table are used to
load-share forwarded packets. If this command is disabled, the route table uses a single "best" route for a
given subnet. If this command is enabled, the route table can use multiple "best" routes and alternate
between them.
Syntax Description
per-destination
per-packet
Default Values
By default, ip load-sharing is disabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 10.1
Usage Examples
The following example turns on load-sharing per destination:
(config)# ip load-sharing per-destination
The following example disables load-sharing:
(config)# no ip load-sharing
61200990L1-35E
Specifies that the route used for forwarding a packet be based on a hash of the
source and destination IP address in the packet.
Specifies that each forwarding route lookup rotates through all the parallel "best"
routes. (Parallel routes are defined as routes to the same subnet with the same
metrics that only differ by their next hop address.)
Command was introduced.
Copyright © 2005 ADTRAN
Global Configuration Mode Command Set
385