Sip Check-Sync Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide Enable Mode Command Set
sip check-sync
Use the sip check-sync command to send a check-sync notification to all IP phones registered to the unit.
When an IP phone receives this check-sync notification, the phone will check for possible configuration
changes stored on the server.
Syntax Description
No subcommands.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 2000 and 5000 Series units.
Command History
Release 11.1 Command was introduced.
Usage Examples
The following example notifies all IP phones to check for a change in configuration:
>enable
#sip check-sync
61200990L1-35E Copyright © 2005 ADTRAN 274