Spanning-Tree Bpdufilter Command - ADTRAN 5000 Series Command Reference Manual

Command Reference Guide
spanning-tree bpdufilter [enable | disable]
Use the spanning-tree bpdufilter command to enable or disable the BPDU filter on a specific interface.
This setting overrides the related Global setting (refer to spanning-tree edgeport bpdufilter default
457). Use the no version of the command to return to the default setting.
Syntax Description
enable
disable
Default Values
By default, this setting is disabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 5.1
Functional Notes
The bpdufilter blocks any BPDUs from being transmitted and received on an interface.
Usage Examples
The following example enables the BPDU filter on the interface eth 0/3:
(config)#interface eth 0/3
(config-eth 0/3)#spanning-tree bpdufilter enable
The BPDU filter can be disabled on the eth 0/3 by issuing the following commands:
(config)#interface eth 0/3
(config-eth 0/3)#spanning-tree bpdufilter disable
61200990L1-35E
Enables BPDU filter for this interface.
Disables BPDU filter for this interface.
Command was introduced.
Copyright © 2005 ADTRAN
Ethernet Interface Configuration Command Set
on page
583